We know that cold-pressed terminals are used to realize electrical connection as an accessory product, and are classified into the category of connectors in industry, just like terminal blocks. In a narrow sense, cold-pressed terminals serve for wire connection. With the increasing degree of industrial automation and stricter and more precise industrial control requirements, the amount of cold-pressed terminals is gradually increasing. With the development of the electronics industry, the scope of use of cold-pressed terminals is increasing, and there are more and more types.

　　When using cold-pressed terminals, pay attention to the following 4 points:

(1): When cleaning the cold-pressed terminal, it is best to wipe it with a silk cloth dipped in absolute ethanol and wait until it is completely dry before using it. Do not use acetone, which may cause damage to the connector, or other chemicals. The solvent cleans the cold-pressed terminals.
(2): When the cold-pressed terminal is in a separated state, a protective cap should be installed on the cold-pressed terminal, or other measures should be adopted to prevent dust, but if the cold-pressed terminal is connected, it will not be separated for a long time If so, it is best to take corresponding measures for insurance between the socket and the plug.

(3): If you need to solder the cold-pressed terminal, you should first select an electric soldering iron with the same power according to the diameter of the bare wire. When soldering the contacts, the longest time should not exceed 5s, and the flux should also be ten million. It cannot penetrate into the insulator to avoid a serious decrease in the resistance of the insulation.

(4): When testing and accepting cold-pressed terminals, it should be formulated according to the relevant standards of the product and the instructions for use. If it is to inspect and accept the used electrical connectors, it must be in the relevant On the basis of the standard and the instruction manual, the requirements will be appropriately reduced. The cold-pressed terminals used on the tooling must be intact and the performance must be qualified. The probe must meet the standard requirements, otherwise the jacks Cause a more serious impact.

https://www.kf-terminals.com/